Monday, May 9, 2011

Frame clean up starts

The clean up on the frame is almost done. I tackled most of the engine mounts and neck today. I filled in all the holes except the one, and I took out the spot welded stamped steel gusset. Nothing structural really except holding the two stamped halves together. I was surpised how bad a lot of the welds are on this frame that are from the FACTORY. Not mine! Lots of porosity in spots, and most of the welds look like they were way too cold. So I had to go through and clean those up too.

All cleaned up, center section was welded back up and ground smooooooth.

No comments:

Post a Comment